Reply to thread

Message: [QUOTE="ETS, post: 858613, member: 17978"] I doubt 50:1 spun your bearings on your old KTM. It was probably like you said "old". My 01' did the same spooge all over the rear fender as yours. I run 32:1 like it says. I went with a leaner pilot jet but I can' remember the #. This was just to clean up the blubbery low end and cold fouling. Then I did the slide cut that has been talked about often on this site. I took the minimum amount as a base line and was happy with that so I left it alone. I left the main jet alone because I don't ride the bike in the upper rpm's much. The pilot/slide cut really cut down on the spooge on the fender. Didn't cure it but it cleaned up 75% of it and I had a lot. This bike spooged more than any other 2stroke I've owned. I think I can do even better playing with it when winter is over. [/QUOTE]