I've been doing some experimenting with the forks on my stock 1997 KDX and I've gotten myself stuck. Someone at the JustKDX forum suggested posting this question here, so I thought I'd give it a try. I've been dinking with the shim stack on the forks and I've kinda lost track of the assembly order of some of the little parts. :bang: I was wondering if you might remember how these little buggers go together.
Here is where I'm currently at:
http://robl245.smugmug.com/photos/183489568-M.jpg
After talking with a few others, my current assumption for how the rest of the parts on the table install is this:
Thin washer goes on next, followed by the shims, then the little round part with the 6 holes in it (flipped over??), then the spring (flipped over), then the little holder thing with the fingers (flipped over), then that little spacer / collar thing (flipped over) and the nut. Do I have this right?
Thanks a lot,
Rob
Here is where I'm currently at:
http://robl245.smugmug.com/photos/183489568-M.jpg
After talking with a few others, my current assumption for how the rest of the parts on the table install is this:
Thin washer goes on next, followed by the shims, then the little round part with the 6 holes in it (flipped over??), then the spring (flipped over), then the little holder thing with the fingers (flipped over), then that little spacer / collar thing (flipped over) and the nut. Do I have this right?
Thanks a lot,
Rob
