Reply to thread

Message: [QUOTE="CRguyStan, post: 1000964, member: 27016"] Jason, I forget the details, but I know I went one notch leaner on the needle and milled an extra 1mm off the backside of the slide on my 01. It prettymuch was snappy throughout with a very strong mid, not like a 97 motor, but deserving of apprecitation. I went from that to my 03 which is jetted correct and has the power, but with the case reeds is far flatter on the bottom-mid, which I think is mainly from the servo powervalve. Play with the jetting and the mods and you will be on track, this bike should come on strong out of the gate with stock porting. Stan [/QUOTE]