The bikes almost back together but...

[MoO_coW]

In the right crank case for my 98 cr 125 there is a housing for the power valve actuating arm, at the bottom of it(going into the case) there is a little drainage hole, does anyone know where this goes? I put some kerosene into it to clean it out because it was pretty dirty and it all disappeared! :scream:

 

[yzeater]

You looked at this yet?
http://www.servicehonda.com/HARD PARTS/off road/CR125R 1998-1999/CR125R_1998_1999.htm

 

[MoO_coW]

yep, ive looked at that, it looks like it opens up into a larger cavity, but where does that go to? Does it just go into that cavity and stay there?

 

[marcusgunby]

Yes it has a drain plug on the front of the engine case-the bolt is the same as coolant drain bolt.It needs to be removed and left to drain occasionally.

 

[MoO_coW]

Thanks alot!

 

[Durt Cycler]

Yea Marcus is right, I had one on my CR engine but for some reason I never had to unscrew it cause nothing would drain out :confused:.

 

[UKcr125rider]

I think that screw is to allow any unburnt 2 stroke oil to be drained of the power valve and linkage etc on that side!