Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Tool making-50mm fork cap wrench
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="c-squared, post: 24986, member: 20161"] I've read where some have been able to fabricate the 50mm cap wrench, just wanted to know how you did it? I keep looking at 3" flat bar stock at Lowes thinking I can cut the pattern with a Dremel, but experience tells me that it would likely be a lot harder to do than I think. Before I shell out $28.50 + shipping to Atomic22 I wanted to check to see if there was an easier and more cost effective solution. I've already learned my lesson on prior bikes with cresent and pipe wrenches. Thanks for any help. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Tool making-50mm fork cap wrench
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom