wornknobby
Member
- Feb 5, 2004
- 625
- 0
quik question...
I know that wheel bearings arn't supposed to just fall out,, but when i took the rear wheel off on the rotor side the wheel spacer doesnt go in as far as it does on the sproket side. but my problem is the bearing on the rotor side just comes out with a few LIGHT taps. :ohmy: the other side is fine but the pin that goes between the two bearings can only go so far. the wheel goes together fine and isn't crooked or anything but i just thought this was weird.? :coocoo:
I know that wheel bearings arn't supposed to just fall out,, but when i took the rear wheel off on the rotor side the wheel spacer doesnt go in as far as it does on the sproket side. but my problem is the bearing on the rotor side just comes out with a few LIGHT taps. :ohmy: the other side is fine but the pin that goes between the two bearings can only go so far. the wheel goes together fine and isn't crooked or anything but i just thought this was weird.? :coocoo: