01 cr 250
- Thread starter cr carl
- Start date
as I posted in the other thread, I also run the clip in pos.1 (to be honest, I lowered the needle seat 1mm so i could make it 1 Pos. leaner than stock).
for me the suspension was top and the motor was disappointing, but with a good pipe it could be a great motor ;)
for me the suspension was top and the motor was disappointing, but with a good pipe it could be a great motor ;)
You mean like my '03 :ride: ??oldfrt613 said:
http://www.asrcorporation.com/motorcycles/images/03CR250/Engine/Finished.JPG
do you realize that only honda riders who have never ridden a kawi or yami say that :pmx547 said:
but to be honest, if you like plenty of power on top, the cr is first choice. I prefer a lot of pull down low and it's a fact the cr doesn't have it compared to KX and YZ
The best thing that I did for my 01 was to replace the stock Mic carb with a Keihen (sp?) from a 2000 CR250. There is a long thread on this conversion somewhere on this site. I never could get the stock carb to stay jetted right. This conversion costs around $200 (from Servicehonda.com) if I recall correctly and is a direct drop in replacement.
Ditto to this:
"The best thing that I did for my 01 was to replace the stock Mic carb with a Keihen".
I never even ran the bike with the stock carb. Anyone need an unused Mikuni for an '01 CR250?
Every year this bike just gets better...so I'm hangin on to it until the "Will-imposing 4 stroke advocates" pry it's grips from my cold, dying hands.
"The best thing that I did for my 01 was to replace the stock Mic carb with a Keihen".
I never even ran the bike with the stock carb. Anyone need an unused Mikuni for an '01 CR250?
Every year this bike just gets better...so I'm hangin on to it until the "Will-imposing 4 stroke advocates" pry it's grips from my cold, dying hands.