DeeziDennis
Member
- Oct 29, 2002
- 24
- 0
I recently got my old 2 Stroke yamaha Enduro 100cc out of 15 year storage and did all the specific steps to get it going.
I cleaned the tank. I also drained the tranny and installed new clutches and steels. I bled the Oil Injector and it seems to be working fine. I drained the carb before I put it away for storage.
The bike fired up after 2 kicks and settled into a nice idle after it warmed up and the choke was pushed in.
I can get about 1/4 rpms but thats about it and thats with the throttle pegged. It just levels out and bogs a little it sounds like..
If I let it sit idling for a second I can rev fast and hit high rpms for a second and then it just goes back to what it was doing before. I pulled the carb and disassembled it and cleaned it. It looked fine.
I put the carb back on and it still does the same thing. I adjusted the crap out of the mixture screws even though I set it to factory specs and it didnt help a thing.
Any Ideas
I cleaned the tank. I also drained the tranny and installed new clutches and steels. I bled the Oil Injector and it seems to be working fine. I drained the carb before I put it away for storage.
The bike fired up after 2 kicks and settled into a nice idle after it warmed up and the choke was pushed in.
I can get about 1/4 rpms but thats about it and thats with the throttle pegged. It just levels out and bogs a little it sounds like..
If I let it sit idling for a second I can rev fast and hit high rpms for a second and then it just goes back to what it was doing before. I pulled the carb and disassembled it and cleaned it. It looked fine.
I put the carb back on and it still does the same thing. I adjusted the crap out of the mixture screws even though I set it to factory specs and it didnt help a thing.
Any Ideas
Last edited: