I'm in the middle of a top-end rebuild and cleaned the power-valve while the cylinder is off, question is: Do I need to lube the power valve components with anything? I cleaned everything to look new and sprayed some WD40 on the parts to keep them from rusting while its apart and installed a new PV bearing but action is still a little rough.
2000 cr 250 power-valve lube???
- Thread starter toddb3
- Start date
Use a lithium based moly grease to lube it up.
Doesn't matter what thickness the grease is, as most of it will be pushed and burnt off. The moly will remain and help to plate the mating surfaces.
A moly fortified rebuild paste would be even better.
Doesn't matter what thickness the grease is, as most of it will be pushed and burnt off. The moly will remain and help to plate the mating surfaces.
A moly fortified rebuild paste would be even better.
