Marcus, I am planning to replace my piston and ring for the first time in the next couple of weeks. Also, since it is winter, I am planning to raise the needle one position. I haven't attempted to adjust my airscrew yet. What is the typical adjustment when you change the needle postion? I believe that I will try 50/50 race gas, since the CR engine seems to rattle quite a bit.
Also, I know that the vertex race piston recommends race gas because of the increased compression. If I switch to this piston, could I use the thin cometic base gasket? Or, would this be too much compression. I know that this setup would require race gas.
I am going to order the V-force reed cage, which setting do recommend on this?
Thanks for the info,
Jay-R