i bought this bike used, the end cap on tail pipe was screwed on, of course these keep vibrating loose. so ive got some rivets now and some new packing, i only remember having the packing inside , no tube with holes in it to wrap the packing around then insert, i only seen packing. Does anybody know if all that goes in there is the packing or do i need to try and find a a tube to wrap the packing around before i rivet it shut.
the holes might be a little further down the silencer. you will prob. have to take off the whole cannister to see them. if they are plugged up, take some solvent and a wire brush to clean them out...then repack it... :cool:
Okay i took a flash light i can see old packing and tube with holes in it, now does this peice just lift out or do i have to take something else apart?
I had an '89 CR250. You should just have to take the screws out of one side and then pull the canister off. You may need to tap it with a mallet to get it to break lose.