I just found this forum and am in need of a lil help. I have a 94 kx 125 with a new bottom end and freshly bored and plated cylinder. My local engine builder told me I could go 2mm over to a 56mm piston to make it a 134. Problem is wiseco and every other piston maker does not make a 56mm for a 94. My question is would the 95-97 56mm wiseco work. Looking at the manual they look very similiar and the rings are offset to clear the ports. The plating company matched a 2004 center pinned piston to my cylinder and sent it to me. But I can't run it since its inline with my intake port. Any help is appreciated.