I'm stuck- Was all set to change the front pads on 97 CR250, manual says to "remove pin plug" and then unscrew the bottom caliper pin using a hex key or torx key to take out the slider pin which retains the bottom foot of the pads.
The "plug" is a dark metal slug which has a crude "slot" milled into it. I tryed using the slot as a screwdriver slot, no good. I tryed to pull it out with needle nose, no good. And, I tried to use a punch and hammer to get under the perimeter and pry it out- no good.
Question is, how is the friggin thing supposed to be removed?
thanks in advance,
Greg
The "plug" is a dark metal slug which has a crude "slot" milled into it. I tryed using the slot as a screwdriver slot, no good. I tryed to pull it out with needle nose, no good. And, I tried to use a punch and hammer to get under the perimeter and pry it out- no good.
Question is, how is the friggin thing supposed to be removed?
thanks in advance,
Greg