kmx125r
~SPONSOR~
- May 23, 2000
- 127
- 0
Good afternoon,
I have a question concerning swapping carbs... I have a 1992 KDX250SR (not exactly the same as the US version)... I have the jetting sorted out pretty well using the stock 32mm PWK carb. I recently acquired a 35mm PWK from "that" auction site... I'm looking for recommendations for a starting point for jetting the "new" carb before I install it.
For instance... should I go up one or two jet sizes on the main and pilot? Use the same slide and needle that I have now? I'm just looking for some ideas or thoughts to get me started...
Thanks!
I have a question concerning swapping carbs... I have a 1992 KDX250SR (not exactly the same as the US version)... I have the jetting sorted out pretty well using the stock 32mm PWK carb. I recently acquired a 35mm PWK from "that" auction site... I'm looking for recommendations for a starting point for jetting the "new" carb before I install it.
For instance... should I go up one or two jet sizes on the main and pilot? Use the same slide and needle that I have now? I'm just looking for some ideas or thoughts to get me started...
Thanks!