i have all my plates, ive narrowed it down to wrong ajustment i know for sure, but i cant get the ajustment corret. earlyer this morning i disengaged the clutch cable from the release arm (so there was no clutch) went down a hill, put it in 1st gear and...OMG WAS IT FAST!!! it ran exactly how it should! so i know that it has nothing to do with the springs or anything, it rode so good! of couse i did not go out of fist gear cuz i didnt want to mess it up, but after i felt that it was very powerful, like this thing flew! ive never had it ride that fast and powerful b4. i pressed the off switch and put the bike away. But here is what i dont get. The clutch release arm is suppost to be set between two case marks on the engine. i cant even get the cable to reach anywhere near that distance. when ive tried to ajust it anyway, it was eather semi-engaged, or it wouldnt engae at all, like when i first ajusted it, i held in the clutch and put it in gear, it stalled right away. then i ajausted it more, but then the clutch would be semi-engaged and it wouldnt start withought me giving it gas, then when i put it in gear, the revs idle went WAY down, and when i let out the clutch it went, but slipped at high revs. so i think the problem is eather i got the wrong cable and need a new one, or i need a new release arm? i know the plates are fine, the oil is fine, the springs are fine. ive checked over them all. so would that be my problem?