Well, my DT360 needed a new carb, so I grabbed one off of a RT2 from ebay. I figured since they were both 360s it would fit fine. I didn't look at it closely enough though. The airbox to carb tube is a different size (bigger on the RT) and the carb to intake manifold uses a flange on the RT and another rubber hose on the DT.
I figured people could use this post as a heads up incase they have the same problem I did. I'm thinking about trying to get a RT2 intake manifold and airbox to carb tube off ebay and seeing if that will work. Opinions?
EDIT: Are the reeds supposed to separate from the intake manifold? They look pretty stuck on there, but all the ones off ebay don't have reeds. Should I just pry gently at it?
I figured people could use this post as a heads up incase they have the same problem I did. I'm thinking about trying to get a RT2 intake manifold and airbox to carb tube off ebay and seeing if that will work. Opinions?
EDIT: Are the reeds supposed to separate from the intake manifold? They look pretty stuck on there, but all the ones off ebay don't have reeds. Should I just pry gently at it?