Moto Squid
~SPONSOR~
- Jul 22, 2002
- 853
- 0
2001 cr 125, stock clutch basket and pressure plate...
I got my EBC Er clutch plates and went to install them. Before hand I stacked the new ones next to the old ones and noticed the new ones were actually shorter!! I say what the hell and installed them but now I can turn the inner hub by hand, absolutely NO pressure on the plates. EBC gives you an "extra" fiber and metal plate so I install them too (WTF is with an "extra" anyways?)
All good now BUT when the clutch lever is all the way pulled in that "extra" fiber plate can almost spin past the end of the clutch fingers :eek: But when released it sits flush with the end of the fingers. I'm very concerned about that plate coming out from the end of the basket.... What should I do???
I got my EBC Er clutch plates and went to install them. Before hand I stacked the new ones next to the old ones and noticed the new ones were actually shorter!! I say what the hell and installed them but now I can turn the inner hub by hand, absolutely NO pressure on the plates. EBC gives you an "extra" fiber and metal plate so I install them too (WTF is with an "extra" anyways?)
All good now BUT when the clutch lever is all the way pulled in that "extra" fiber plate can almost spin past the end of the clutch fingers :eek: But when released it sits flush with the end of the fingers. I'm very concerned about that plate coming out from the end of the basket.... What should I do???