Installing Bark Busters

91KDX · Feb 8, 2004

I want to install bark busters on my bike. I have Renthal CR high bars on my 98 KDX 200. I had a set of old Moose Bark Busters, but I dont know how to mount them into the end of the bars. I thought about rounding off a nut slightly and pushing it into the end of the bar a little and then JB weld the bolt in there. Any Suggestions? I would like to beable to take the bark busters off since I just completed the KX front end mod, and I am going to want to ride a little bit of track. Thanks in advance.

Ben

91KDX · Feb 8, 2004

I was also wondering if anybody had any suggestions for a Clutch Assembly and new grips? Thanks

Ben

bh · Feb 8, 2004

If you are going to use your barkbusters with aluminum bars you need a set of wedge-locks like come with a new set of barkbusters. I dont know where you can get them seperatly but they shouldn't be too hard to find.

For a clutch assembly I assume that you mean lever and perch? If you do I'd suggest the MSR Raptor. Its the one with three differant settings of pull. It gives you alot easyer clutch pull plus the shorty lever clears the barkbusters really well.

And for grips I like the scotts half waffle half smooth ones. I can't remember what they are called right now though.

91KDX · Feb 8, 2004

Thanks, actually I was looking at the Raptor Clutch perch today. I think that is the way to go. And I think I can get the locking mechanism your talking about through FRP. Thanks

Ben

BRush · Feb 8, 2004

See the "ENDURO ENGINEERING TAPER LOCK BAR ENDS " on this link.

http://www.kevinscycleracing.com/brushguards.htm

Installing Bark Busters

91KDX

91KDX

bh

91KDX

BRush

Similar Topics

Privacy & Transparency

Privacy & Transparency