mxracer2000

Member
Jan 6, 2000
100
0
I'll start by saying I've had this bike for several years and have done most of the maintenance myself. I ended up having to get the bottom and top end done over the winter and decided to get a shop to put it all back together for me. I installed the motor into the bike and was responsible for putting back the flywheel and stator. Well it all bolted back up fine. I put new gas in the bike, have good spark, the timing is set properly but I cant get it to start at all. I occasionally get a backfire and that's it. I had a reputable shop do the work but I just cant figure out why it wont start.
Any ideas or suggestions?
 

Patman

Pantless Wonder
LIFETIME SPONSOR
Dec 26, 1999
19,774
0
Check the air gap on the stator pickup? Is the plug wet?
 

mxracer2000

Member
Jan 6, 2000
100
0
No, the carb is clean as a whistle. I completely disassembled and cleaned it and it has a fresh tank of fuel. Definitely fuel flowing through as I leaned t on its side before starting and saw fuel coming out the overflow
 
Top Bottom