mark '87 930
Member
- May 29, 2007
- 8
- 0
Hey guys, new to this forum, but alright with a set of tools.
I have an '88 CR125 that starts and idles fine. But the bike does not want to go into high rpm. It's kind of like it's hitting the rpm limiter. It does this if you wind the throttle in neutral, or when you are under load and you want to give er.
The previous owner seemingly had spliced in another stator at some point and did a bad job of splicing the wires together, so I cleaned that all up and soldered them together and put it all back together.
What do you think? I checked the jetting and it seems fine. I should also say it was running fine at end of last season.
Stator? (I have another so I can swap to test)
Coil?
CDI box?
carb's (I have another so I can swap to test)
I have an '88 CR125 that starts and idles fine. But the bike does not want to go into high rpm. It's kind of like it's hitting the rpm limiter. It does this if you wind the throttle in neutral, or when you are under load and you want to give er.
The previous owner seemingly had spliced in another stator at some point and did a bad job of splicing the wires together, so I cleaned that all up and soldered them together and put it all back together.
What do you think? I checked the jetting and it seems fine. I should also say it was running fine at end of last season.
Stator? (I have another so I can swap to test)
Coil?
CDI box?
carb's (I have another so I can swap to test)