Putting together a list of parts needed for a ct1 rebuild

[City Hunter]

So, the ct1 I picked up for 50 bucks is in need of a rebuild since the previous owner plowed it through water and killed the crank seals. I figure I might as well throw a new piston in while I'm at it.

So far this is the list of parts i need to do this

piston rings pin clips
complete gasket kit
crank seals.

Anything else I am forgetting? This will be my first rebuild on a motorcycle engine, and a 2 stroke at that. Done quite a few car engines though. I dont know if I should throw new bearings in. The bike wasnt knocking at all, just spit transmission oil out real bad. I'm trying to keep the cost down on it as i have no title for the bike. Not worth dropping much money into.

 

[O3RM125]

wristpin bearing.

 

[2strokerfun]

Yes to main bearings. Don't split the cases and chintz out on $40 or so for new bearings.