i think they're pretty similar forks, my manual says theres an interference fit between the slider bushing and the fork tube bushing, which they're definitely not lying about. on one of the forks the dust seal just slid out by itself(wasnt in there very tight) so i just went ahead and drilled through the oil seal(theres a metal washer behind it), inserted a wood screw, and screwed it in which in turn pryed the oil seal out. so i got all the components out which it said would happen if i pulled hard ect., but even after i got the out the seals, washer, and spacer... the fork tube will still not come out. the manual says it will just slide right out but i think they're full of it.
i went as far as putting the fork tube on a vise(the vise is attached to a 300lb table) and hooking the slider end up to the forklift and reversing, but all that happened was i pulled the table! :-/
for the other fork i think im just gonna drill through the dust seal and oil seal and do the same thing i did with the other, then just put some gasket sealer in the drill hole of the dust seal when i re-use it seeing as they dont really have that much of a purpose