Jetting maybe, 2000 RM 125
Yes its me again, still working on getting the old girl running. This time I come to you with a possible jetting problem. I installed my new carb, and it wouldnt run (unless i jump started it), and then i got some fresh gas and mixed properly, and that helped. So my bike when cold starts perfectly one kick and shes going, so i ripped it up and down my street, then when i let it sit for a few minutes it wont start (when its hot), unless i kick it and give it some gas then it starts, but it revs really low and almost dies, so i rev it up a bit and it goes back to normal.
So I set my air screw to 3 turns out which seems to be the best, my manual suggests not putting the air screw more than 2 and half turns out, i was wondering if it is bad to leave it at 3 ?
I checked the plug and it was burnt white, but still sparking good. I dont know what to do, sure my bike runs good when cold, but I think it might be overheating a bit, adn I dont want to take it to the trails cause i dont trust it will keep running.
Please help.
THanks