spokes on a xr80r

P

prindle470

Member

Nov 12, 2007

17

0

• Nov 13, 2007

• #1

recently i have been letting my dad use my xr80r to learn to ride. i know the bike is way too small for him, but he is well under the max capacity and he NEVER goes more than 20, and the spokes keep breaking on the rear wheel. i have had the tire off more times than i can count. what is happening. is there too much pressure on the wheel, or do i suck at tentioning the spokes.

 

Patman

Pantless Wonder

LIFETIME SPONSOR

Dec 26, 1999

19,765

1

• Nov 13, 2007

• #2

You suck at tensioning spokes. Our XR80 has hauled my +200# butt around at well over 20mph over some pretty rugged trails and zero issue.

 

P

prindle470

Member

Nov 12, 2007

17

0

• Nov 13, 2007

• Thread starter
• #3

so how do i get the spokes right. does the rim need to go to the shop?

 

Patman

Pantless Wonder

LIFETIME SPONSOR

Dec 26, 1999

19,765

1

• Nov 13, 2007

• #4

It might not hurt to have it put on a truing stand. Hard to say what's wrong at this point.

 

P

prindle470

Member

Nov 12, 2007

17

0

• Nov 13, 2007

• Thread starter
• #5

if i find a square driver bit that fits into the nut on a spoke, and i pull the tire off, could i tention the spokes with a drill by adjusting the clutch on the drill and just going around the rim and tighening opposite spokes or will this screw everything up.

 

Patman

Pantless Wonder

LIFETIME SPONSOR

Dec 26, 1999

19,765

1

• Nov 13, 2007

• #6

Considering I have no idea what has been done to this point or even if the rim is our of round I'll stick by my last suggestion.

 

P

prindle470

Member

Nov 12, 2007

17

0

• Nov 13, 2007

• Thread starter
• #7

sounds good.

 

R

Rotorranch

Member

Feb 10, 2007

436

0

• Nov 13, 2007

• #8

Patman said:

You suck at tensioning spokes. Our XR80 has hauled my +200# butt around at well over 20mph over some pretty rugged trails and zero issue.

Click to expand...

Patman...your subtlety overwhelms me. :laugh:

Rotor