I wish my bike could go out and get a job to help with it's parts bill!
Originally posted by Racinante
Nice pic there Mac! I assume the rope was there to protect the swing arm from the table. Is that right? So, I just need to be careful to get the right sized socket so that it only contacts the outer race? My Kaw book says to measure the distance that the bearing recesses into the whole, and match that same distance with the new bearing. Should I just make sure the bearing is centered between each side, instead?
Originally posted by Racinante
Heat tape? I'm a lil' confused. Did you heat up the swing arm for removal, or installation? Kind'uv like the interference fit for the crank bearings?
Originally posted by Mac
heat tape heats slowly.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?