04 husky wr250 power valve - exhaust valve install question
Here's a quickie.
Should the 2 bearings on that sit on the exhaust shaft fit loosely on the shafts. Seems as though the shaft spins freely inside without spinning the bearings. I tried new bearings as well. Just want to make sure there are no tricks prior to slapping everything back together
Should the 2 bearings (the ones that are sandwiched between the cylinder and exhaust cover) that sit on the exhaust valve shaft fit loosely on the shafts. Seems as though the shaft spins freely inside without spinning the bearings. I tried new bearings as well.
How much side to side play should there be?
also the exhaust valve bearings once everything is assembled can be easily pushed out by pushing on the ends of the exhaust valve and pushed back in by hand - is this normal?
Are there any tricks prior to slapping everything back together