Broken screw.

[LosT_PropheT]

I was putting the clutch cover back on after replacing the clutch center and plates, when I was tightening the screws to the cover back on, one of the short screws broke. I figured it would be good, since there are like 5 other screws still in it? Any clues?

 

[IndyMX]

Clutch cover or Pressure Plate?

Either way, you should fix it.. It's going to be nothing but trouble if you don't.

If it's the cover, you might be able to take it off and turn the broken part out with a pair of plyers.

 

[LosT_PropheT]

It's the cover, and it looks like, it broke past the cover itself.

 

[76GMC1500]

The is one of the only situations where an Easy-Out would work.

 

[IndyMX]

It's the cover, and it looks like, it broke past the cover itself.

Take the cover off.. Most likely you won't need an eazyout.. Just try to get ahold of it with pliers, or a small pick or something like that.

 

[LosT_PropheT]

The is one of the only situations where an Easy-Out would work.

That's what I plan on falling back on, but it'll be fine until then??
I still have to wait until I get the screw, I just want to do some riding bad, because the season is almost done.

 

[LosT_PropheT]

Clutch cover or Pressure Plate?

Either way, you should fix it.. It's going to be nothing but trouble if you don't.

If it's the cover, you might be able to take it off and turn the broken part out with a pair of plyers.

I definitely plan on getting i fixed, I was just curious if I would be good for the short term..