KxRider250

Member
Apr 20, 2006
11
0
My front brake just decided to stop pushing fluid one day.

I replaced the plunger, spring and the 2 rubber seals that are on the plunger. I also disassembled the seal on the inside of the reservoir and cleaned everything in the parts washer.

What else is there to do??? It still does not push any fluid :bang:
 

Rich Rohrich

Moderator / BioHazard
LIFETIME SPONSOR
Jul 27, 1999
22,839
16,904
Chicago
Assuming you assembled the master cylinder correctly then it's just a matter of getting all the air out, which can be kind of tough. Sometimes it's necessary to raise the caliper above the master cylinder to get the air to move. Tapping the master cylinder with the handle of a screw driver while bleeding can help move the air as well.
 

Welcome to DRN

No trolls, no cliques, no spam & newb friendly. Do it.

Top Bottom