Cr 125 1997 coil resistence.values....HELP Eric
HI Eric
Thanks for share your knowledge, your book is a "tool" for me so.....
I dont have the owner´s manual of this bike, so i need the coil resistence values, because my bike don´t start and want to verify the stator.....
My bike was stoped 2 years, so start ok over 20 minutes, and later stoped and never start again....
The spark is so weak, that i supouse that the wet sand and dust inside the ignition room and inner rotor flywheel lmake the coils performance down..........and the coils in the stator have a lot clearence and maybe disaligment the magnetic waves ...
Anyway.....my tester show me:
Ignition coil :
primary 1 Ohm
secondary 18 K Ohms (with spark plug cap) and 13 without
Stator:
Ignition pulse 240 Ohms
Exiter coil 65 Ohms.....................possible failure
I dont have the Peak voltage adaptor module in my tester, so i can´t measure the peak voltage ...............
After re-wire my new exciter coil have 150 Ohms, and problems continue.....!!!!!!!!
i will glad if you confirm the resistence value for this model...1997, because i dont trust in that value, the big CDI unit maybe need a different value....!!!!!!
Thanks Eric, i'm waiting your reply, because nobody answer my question y other forums.......