Race sag

[KDXFORU]

I have tried to use the search feature and once again I cant find what im looking for. :bang: Maybe someone can give me a clue on how to search. ANYWAY.

Can someone direct me to a link on this wonderful forum about setting race sag for a 92 KDX 200. Im sure this topic has been brought up at least once. :aj:

Thanks

 

[Quailchaser]

1. Set bike on a stand (not the kick stand) so that the rear tire is off the ground.
2. Mark a spot on the rear fender directly above the rear axle bolt.
3 Measure from the rear axle bolt to the fender where previously marked.
4. Write this number down.
5. Get someone to help with the next few steps.
6. Con said person into removing the bike from the stand while you put on your all of your normal riding gear.
7. Have said person hold the bike and measuring device while you get on the bike.
8. Stand on the bike in your "attack" riding position.
9. Have helper measuer from the axle bolt(same place you measured from on the bolt) to the marked point on the rear fender.
10. Write that number down.
11. Once you and your bike are secure from falling over...subtract the second number you wrote down from the first number you wrote down.
12. The difference should be approx. 4 inches.
13. If it is not, adjust rear spring as per your manual until you reach the desired sag.

Good luck.

Later
Robb

 

[KDXFORU]

Sweet!