Replacing old graphics??

[yz400fer69]

I just bought a new set of graphics today for my 99yz400. I bought the One Industries Techno Flew graphics? Got a really good deal. But the guy at the shop said something about leaving them in the sun for a little while before putting them on so the glue will heat up? Is this true? Also how do I remove the old graphics? Do I just peel them off and clean with alcohol? When I stick the new ones on what are some tips to getting it smooth and straight?(no air bubbles, stickers will match up exactly to the seat, ect. ect.) Thank You

 

[Fred T]

Use a hair dryer

to heat them up as you put them on. I also got an exacto knife to trim some of the stickers around holes and edges. When I got them on OK I stuck them in the oven for a few minutes and I pulled them out and smoothed them down real good. Be careful not to set the oven above 200 degrees and don't leave them in there for too long. :scream:

Let them cool off and you are good to go.