L.G.H

Member
Aug 5, 2019
5
8
Hi guys. Im new to this forum but i hope you guys can help. I have brought a 2011 kx85 to strip down and do up. I am trying to make my mind up if i can strip the paint off the standard pipe and get it to the bare metal or if this is a bad idea. The pipe has gone rusty in spots and doesn't look very good so if i could get it to the bare metal without any problems that would be perfect. Hope you guys can help. Thanks
 

Rich Rohrich

Moderator / BioHazard
LIFETIME SPONSOR
Jul 27, 1999
22,839
16,904
Chicago
This will take it off. 1565054230735.png

https://www.amazon.com/Permatex-80645-Low-Gasket-Remover/dp/B0018PXX2I

1565054230735.png
 

The Redrider

Member
Jun 14, 2019
238
32
Hi guys. Im new to this forum but i hope you guys can help. I have brought a 2011 kx85 to strip down and do up. I am trying to make my mind up if i can strip the paint off the standard pipe and get it to the bare metal or if this is a bad idea. The pipe has gone rusty in spots and doesn't look very good so if i could get it to the bare metal without any problems that would be perfect. Hope you guys can help. Thanks
Sand blast it, then clean it up with cleaners and buy some hot rod header high temp paint, and you shoul be good to go...
 

The Redrider

Member
Jun 14, 2019
238
32
Thanks for the message. Would i be able to leave it with the bare metal or would that just cause problems?
You could leave it bare metal, I did that with an old dg pipe back in the day, It gives it a "works" bike look. Just be sure polish it up, and after riding it coat it with wd-40. When it gets rusty, use a scotch brite pad, and coat it with wd-40. It will ok...
ab861928c3187b71ac5be41cb58a9df7.jpg
Unfinished Works bike pipe that Jeff Ward used in 88, 52 hp engine at the flywheel...
 

L.G.H

Member
Aug 5, 2019
5
8
You could leave it bare metal, I did that with an old dg pipe back in the day, It gives it a "works" bike look. Just be sure polish it up, and after riding it coat it with wd-40. When it gets rusty, use a scotch brite pad, and coat it with wd-40. It will ok... View attachment 20498 Unfinished Works bike pipe that Jeff Ward used in 88, 52 hp engine at the flywheel...
Perfect thanks for the message. Love a bit of polish anyway should change the look of the bike completely. Thanks
 
Top Bottom