tsnobaddays
Member
- Feb 11, 2008
- 39
- 0
I removed my rear wheel completly off the bike. When I
installed back on the bike and started to snug down on the
rear axle nut it puts something in a bind and the rear wheel
won't turn as freely as it should.
Axle block marks lines up on both sides
It was fine before I took off
The chain guide isn't in the way of anything
The axle bolt is put in on the correct side
I have a manual and followed instructions step by step and
still no luck. Any suggestions.
installed back on the bike and started to snug down on the
rear axle nut it puts something in a bind and the rear wheel
won't turn as freely as it should.
Axle block marks lines up on both sides
It was fine before I took off
The chain guide isn't in the way of anything
The axle bolt is put in on the correct side
I have a manual and followed instructions step by step and
still no luck. Any suggestions.