fmxhero

Member
Apr 14, 2010
4
0
1989 kx 250

just put in a clutch from another motor the guy told me it was a new clutch when i got done putting in the clutch from the other motor the clutch handle would not tighten up at all even after i ajusted it still the clutch would not work the clutch would not work. any sugestions?
 
Last edited:

ellandoh

dismount art student
~SPONSOR~
Mi. Trail Riders
Aug 29, 2004
2,958
0
my 88 cr250 had a little ball bearing behind the push rod, that rolled out and almost was unnoticed. im unfamiliar with the kx though
 

IndyMX

Crash Test Dummy
~SPONSOR~
Jul 18, 2006
5,548
2
Amo, IN
fmxhero said:
just put in a clutch from another motor the guy told me it was a new clutch when i got done putting in the clutch from the other motor the clutch handle would not tighten up at all even after i ajusted it still the clutch would not work the clutch would not work. any sugestions?


....... ,,,,,,, here.. you seem to be out of these..

As for the clutch, according to the fiche on bikebandit.com, there's a shaft & bushing.. without that part, the lever will never get tight.

Seems like its an available part:

92028: BUSHING 625447-001 $19.30
 

Welcome to DRN

No trolls, no cliques, no spam & newb friendly. Do it.

Top Bottom