Can anyone give me some advice on getting the the seals on my 92 200E4.
Do I need to undo the bottom compression valve to release the slider. Is there any special tools required.
Cheers
Gray
To separate the inner tube from the outter tube requires a special Kawasaki Tool #57001-1057 and 57001-183 (which is a long rod and a "nut" like end that fits down inside. The outside requires an allan key. This is one job that needs the right tools.
I'd rather have the mechanic do the job than to delve into that job.
Done that a work tonight :laugh: and it came out a treat....so much for factory tools.
I must confess however that my mate sussed it out as soon as he had seen the problem(thanks Andy)
He only used a bit an 18" length of stud bar with two nuts at each end plus the 14mm allen key.
My next question is what is the "coating" on the bottom part of the slider....teflon??
Sorry yes I mean the shiny chrome one. At the bottom there is a thin brass(??) bush with grey coating. One is in perfect condition but is peeling off. Just wondering what it was.
Cheers
Gray
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.