Forget the presses. You can make yourself a nifty bearing press/puller EASY. Just go down to the hardware store and get yourself a piece of "allthread". Get the biggest size that you can fit thru the middle of your 1/2 in socket set. Also get several nuts and washers. Use two nuts on one end jammed together, then find a deep well socket a little larger than the bearing you are pressing out, then find one that is about the same size. Run the allthread thru the socket, the bearing and the other socket....then screw a nut on the other end. Then take your wrenches and tighten down the nuts. The socket that is slightly smaller then the bearing will press the bearing out the other side INTO the socket that is slightly larger than the bearing. No hammering or risk of damage from hammering bearing. They just slide out. (works on putting them in also!!). Couple of bucks at the hardware store and your deep well socket set and you have a very nice, variable size bearing press that you can make yourself and works GREAT!