OK so I'm replacing the "relay arm" and all the bearings and pivot bolts on my rear suspension. See:
http://dirtrider.net/forums3/showthread.php?threadid=23815
There's eight total bearings to press out/in including the swingarm. Me being Me I see this as justification to go out and buy a 20 ton press. Harbour Fright - $200.
I can make a press tool from barstock.
Any comments on this plan or advice? Do you use heat or freeze the bearings or anything else heroic?
BTW, 98 YZ250
http://dirtrider.net/forums3/showthread.php?threadid=23815
There's eight total bearings to press out/in including the swingarm. Me being Me I see this as justification to go out and buy a 20 ton press. Harbour Fright - $200.
I can make a press tool from barstock.
Any comments on this plan or advice? Do you use heat or freeze the bearings or anything else heroic?
BTW, 98 YZ250